如何做木工雕刻机网站wordpress登陆不跳转
一.200.1.1.0/24子网划分
1.划分八个子网
2.选用前5个，第五个子网再划分4个子网作为骨干
二.规划路由
三.配置（下一跳）
1.先依次实现四个路由器之间全网可通
2.为路由器配置地址池，使用全局模式获取dhcp，指定网关和dns
3.PC测试
一.200.1.1.0/24子网划分
1.划分八个子网
200.1.1.0/27
200.1.1.32/27
200.1.1.64/27
200.1.1.96/27
200.1.1.128/27
200.1.1.160/27
200.1.1.192/27
200.1.1..224/27
2.选用前5个，第五个子网再划分4个子网作为骨干
200.1.1.128/29
200.1.1.136/29
200.1.1.144/29
200.1.1.152/29
二.规划路由
AR1：
到达200.1.1.0/27一条
到达200.1.1.64/27一条
到达200.1.1.96/27两条
到达200.1.1.144/29一条
到达200.1.1.152/29一条
AR2：
到达200.1.1.0/27两条
到达200.1.1.32/27一条
到达200.1.1.96/27一条
到达200.1.1.128/29一条
到达200.1.1.152/29一条
AR3：
到达200.1.1.32/27两条
到达200.1.1.64/27一条
到达200.1.1.0/27一条
到达200.1.1.128/29一条
到达200.1.1.136/29一条
AR4:
到达200.1.1.64/27两条
到达200.1.1.32/27一条
到达200.1.1.64/27一条
到达200.1.1.136/29一条
到达200.1.1.144/29一条
三.配置（下一跳）
1.先依次实现四个路由器之间全网可通
[Huawei]ip route-static 200.1.1.136 29 200.1.1.130
#根据规划路由依次写静态路由实现通信AR1：
[r1]display ip routing-table protocol static
Route Flags: R - relay, D - download to fib
------------------------------------------------------------------------------
Public routing table : StaticDestinations : 5 Routes : 6 Configured Routes : 6Static routing table status : <Active>Destinations : 5 Routes : 6Destination/Mask Proto Pre Cost Flags NextHop Interface200.1.1.0/27 Static 60 0 RD 200.1.1.129 GigabitEthernet
0/0/1200.1.1.64/27 Static 60 0 RD 200.1.1.138 GigabitEthernet
0/0/0200.1.1.96/27 Static 60 0 RD 200.1.1.129 GigabitEthernet
0/0/1Static 60 0 RD 200.1.1.138 GigabitEthernet
0/0/0200.1.1.144/29 Static 60 0 RD 200.1.1.138 GigabitEthernet
0/0/0200.1.1.152/29 Static 60 0 RD 200.1.1.129 GigabitEthernet
0/0/1Static routing table status : <Inactive>Destinations : 0 Routes : 0
AR2：
[r2]display ip routing-table protocol static
Route Flags: R - relay, D - download to fib
------------------------------------------------------------------------------
Public routing table : StaticDestinations : 5 Routes : 6 Configured Routes : 6Static routing table status : <Active>Destinations : 5 Routes : 6Destination/Mask Proto Pre Cost Flags NextHop Interface200.1.1.0/27 Static 60 0 RD 200.1.1.146 GigabitEthernet
0/0/0Static 60 0 RD 200.1.1.137 GigabitEthernet
0/0/1200.1.1.32/27 Static 60 0 RD 200.1.1.137 GigabitEthernet
0/0/1200.1.1.96/27 Static 60 0 RD 200.1.1.146 GigabitEthernet
0/0/0200.1.1.128/29 Static 60 0 RD 200.1.1.137 GigabitEthernet
0/0/1200.1.1.152/29 Static 60 0 RD 200.1.1.146 GigabitEthernet
0/0/0Static routing table status : <Inactive>Destinations : 0 Routes : 0
AR3：
[r3]display ip routing-table protocol static
Route Flags: R - relay, D - download to fib
------------------------------------------------------------------------------
Public routing table : StaticDestinations : 5 Routes : 6 Configured Routes : 6Static routing table status : <Active>Destinations : 5 Routes : 6Destination/Mask Proto Pre Cost Flags NextHop Interface200.1.1.0/27 Static 60 0 RD 200.1.1.154 GigabitEthernet
0/0/0200.1.1.32/27 Static 60 0 RD 200.1.1.154 GigabitEthernet
0/0/0Static 60 0 RD 200.1.1.145 GigabitEthernet
0/0/1200.1.1.64/27 Static 60 0 RD 200.1.1.145 GigabitEthernet
0/0/1200.1.1.128/29 Static 60 0 RD 200.1.1.154 GigabitEthernet
0/0/0200.1.1.136/29 Static 60 0 RD 200.1.1.145 GigabitEthernet
0/0/1Static routing table status : <Inactive>Destinations : 0 Routes : 0
AR4：
[r4]display ip routing-table protocol static
Route Flags: R - relay, D - download to fib
------------------------------------------------------------------------------
Public routing table : StaticDestinations : 5 Routes : 6 Configured Routes : 6Static routing table status : <Active>Destinations : 5 Routes : 6Destination/Mask Proto Pre Cost Flags NextHop Interface200.1.1.32/27 Static 60 0 RD 200.1.1.130 GigabitEthernet
0/0/0200.1.1.64/27 Static 60 0 RD 200.1.1.130 GigabitEthernet
0/0/0Static 60 0 RD 200.1.1.153 GigabitEthernet
0/0/1200.1.1.96/27 Static 60 0 RD 200.1.1.153 GigabitEthernet
0/0/1200.1.1.136/29 Static 60 0 RD 200.1.1.130 GigabitEthernet
0/0/0200.1.1.144/29 Static 60 0 RD 200.1.1.153 GigabitEthernet
0/0/1Static routing table status : <Inactive>Destinations : 0 Routes : 02.为路由器配置地址池，使用全局模式获取dhcp，指定网关和dns
[r1]dhcp enable
[r1]ip pool s1
[r1-ip-pool-s1]network 200.1.1.32 mask 27
[r1-ip-pool-s1]dns-list 114.114.114.114 8.8.8.8
[r1-ip-pool-s1]gateway-list 200.1.1.33
[r1]interface GigabitEthernet 0/0/2
[r1-GigabitEthernet0/0/2]dhcp select global
#四个路由器同样做此配置AR1：
[r1]ip pool s1
[r1-ip-pool-s1]display this
[V200R003C00]
#
ip pool s1gateway-list 200.1.1.33 network 200.1.1.32 mask 255.255.255.224 dns-list 114.114.114.114 8.8.8.8
#
return
AR2：
[r2]ip pool S2
[r2-ip-pool-s2]display this
[V200R003C00]
#
ip pool s2gateway-list 200.1.1.65 network 200.1.1.64 mask 255.255.255.224 dns-list 114.114.114.114 8.8.8.8
#
return
AR3：
[r3]ip pool s3
[r3-ip-pool-s3]display this
[V200R003C00]
#
ip pool s3gateway-list 200.1.1.97 network 200.1.1.96 mask 255.255.255.224 dns-list 114.114.114.114 8.8.8.8
#
return
AR4：
[r4]ip pool s4
[r4-ip-pool-s4]dis
[r4-ip-pool-s4]display th
[r4-ip-pool-s4]display this
[V200R003C00]
#
ip pool s4gateway-list 200.1.1.1 network 200.1.1.0 mask 255.255.255.224 dns-list 114.114.114.114 8.8.8.8
#
return
3.PC测试
PC>ipconfig #PC8Link local IPv6 address...........: fe80::5689:98ff:fe61:7b69
IPv6 address......................: :: / 128
IPv6 gateway......................: ::
IPv4 address......................: 200.1.1.29
Subnet mask.......................: 255.255.255.224
Gateway...........................: 200.1.1.1
Physical address..................: 54-89-98-61-7B-69
DNS server........................: 114.114.114.1148.8.8.8PC>ping 200.1.1.62Ping 200.1.1.62: 32 data bytes, Press Ctrl_C to break
Request timeout!
Request timeout!
From 200.1.1.62: bytes=32 seq=3 ttl=126 time=78 ms
From 200.1.1.62: bytes=32 seq=4 ttl=126 time=78 ms
From 200.1.1.62: bytes=32 seq=5 ttl=126 time=94 ms--- 200.1.1.62 ping statistics ---5 packet(s) transmitted3 packet(s) received40.00% packet lossround-trip min/avg/max = 0/83/94 msPC>ping 200.1.1.61Ping 200.1.1.61: 32 data bytes, Press Ctrl_C to break
Request timeout!
From 200.1.1.61: bytes=32 seq=2 ttl=126 time=62 ms
From 200.1.1.61: bytes=32 seq=3 ttl=126 time=79 ms
From 200.1.1.61: bytes=32 seq=4 ttl=126 time=93 ms
From 200.1.1.61: bytes=32 seq=5 ttl=126 time=78 ms--- 200.1.1.61 ping statistics ---5 packet(s) transmitted4 packet(s) received20.00% packet lossround-trip min/avg/max = 0/78/93 msPC>ping 200.1.1.94Ping 200.1.1.94: 32 data bytes, Press Ctrl_C to break
Request timeout!
Request timeout!
Request timeout!
Request timeout!
From 200.1.1.94: bytes=32 seq=5 ttl=125 time=78 ms--- 200.1.1.94 ping statistics ---5 packet(s) transmitted1 packet(s) received80.00% packet lossround-trip min/avg/max = 0/78/78 msPC>ping 200.1.1.93Ping 200.1.1.93: 32 data bytes, Press Ctrl_C to break
Request timeout!
From 200.1.1.93: bytes=32 seq=2 ttl=125 time=94 ms
From 200.1.1.93: bytes=32 seq=3 ttl=125 time=46 ms
From 200.1.1.93: bytes=32 seq=4 ttl=125 time=79 ms
From 200.1.1.93: bytes=32 seq=5 ttl=125 time=78 ms--- 200.1.1.93 ping statistics ---5 packet(s) transmitted4 packet(s) received20.00% packet lossround-trip min/avg/max = 0/74/94 msPC>ping 200.1.1.125Ping 200.1.1.125: 32 data bytes, Press Ctrl_C to break
Request timeout!
From 200.1.1.125: bytes=32 seq=2 ttl=126 time=78 ms
From 200.1.1.125: bytes=32 seq=3 ttl=126 time=78 ms
From 200.1.1.125: bytes=32 seq=4 ttl=126 time=47 ms
From 200.1.1.125: bytes=32 seq=5 ttl=126 time=62 ms--- 200.1.1.125 ping statistics ---5 packet(s) transmitted4 packet(s) received20.00% packet lossround-trip min/avg/max = 0/66/78 msPC>ping 200.1.1.126Ping 200.1.1.126: 32 data bytes, Press Ctrl_C to break
Request timeout!
From 200.1.1.126: bytes=32 seq=2 ttl=126 time=62 ms
From 200.1.1.126: bytes=32 seq=3 ttl=126 time=78 ms
From 200.1.1.126: bytes=32 seq=4 ttl=126 time=63 ms
From 200.1.1.126: bytes=32 seq=5 ttl=126 time=62 ms--- 200.1.1.126 ping statistics ---5 packet(s) transmitted4 packet(s) received20.00% packet lossround-trip min/avg/max = 0/66/78 ms